Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

User

julio pelayo

Joined on the:

Apr. 14, 2015

Score

1650

Comment(s)

24

Voted question(s)

0

Voted answer(s)

3

Votes up

0

Votes down

3

Votes up received

2

Votes down received

0

Recent Activity

Question(s) asked

29

Answered question(s)

0

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question
RECENT ACTIVITY QUESTION(S) ASKED ANSWERED QUESTION(S) COMMENTED QUESTION(S)

22/03/2021

 Ford julio pelayo (1650Pts.)

0

2019 ford f150 won't start

Hi, installed evo all with t harness stand alone and it programmed fine, but it won't start the blue light on evo all blinks blue with 1st and 2nd press but not on 3rd press. Is there a way to activate the evo all to make sure it's programmed right, is there a wire i can ground to activate it? Does option b2 need to be on to add evo all single button one way rf kit ? Does protocol have to be set to fortin or is it automatically set to fortin? SN 001A07011080
Login to reply View 1 answer(s)

22/08/2019

 Ford julio pelayo (1650Pts.)

0

Ford f150 won't start start, what can i check?

Installed fort3 with compustar cmis7000 evo all programmed correctly and truck started first time i tested tried again and now it wont start. Truck has factory hood pin switch and all doors are closed when testing, i replaced the evo all and it did the same thing, only started one time. Compustar remotes work for lock and unlock but won't start. Truck has dealer installed alarm can that be the problem? Do i need to change ignition on compustar from input/out to input only? Service # 001A06893970
Login to reply View 1 answer(s)

23/04/2019

 Ford julio pelayo (1650Pts.)

0

Is safety override switch mandatory if truck has factory hood pin switch?

Hi sorry for asking again, my question was is safety override switch mandatory if truck has factory hood pin switch? If it is can i get ground for it from the black wire off of the data plug wire? Also why doesn't the evo all say what hardware version it is on it and doesn't have a barcode? Installing on a 2017 ford f150 key start with keyless entry using thar fort3
Login to reply View 1 answer(s)

28/03/2019

 Toyota julio pelayo (1650Pts.)

0

Is trunk release connection needed and why? 2019 pts rav4

Is trunk release connection needed and why? On 2019 rav4 pts. Auto lights interruption only needed if i want idle mode? What optins do i need to set to use my car telematics? Do you guys recommend soldering or just wrap and tape?
Login to reply View 1 answer(s)

15/08/2018

 Ford julio pelayo (1650Pts.)

0

Do you guys have a guide for 2015 f50 evo all without t harness

Want to install compustar with evo all on 2015 f150. Want to install without t harness, do you guys have an installation guide without t harness?
Login to reply View 1 answer(s)

13/08/2018

 Ford julio pelayo (1650Pts.)

0

Does evo all with thar for3 support idle mode?

Installing evo all with thar for3 on 2018 f150 and would like to know if idle mode is supported.stand alone installation.
Login to reply View 1 answer(s)

25/06/2018

 Honda julio pelayo (1650Pts.)

0

Does evo all lose programming if unplugged?

Installed evo all with autopage remote start, i already had a remote start installed but replaced it, i took out evo all for about a week i don't know if i have to reprogram it or if something is lose, remote start will work but next day it will start a shut off in about 5sec, i will relearn the tach and it will work again. Will wire to wire just for tach help? Can i check if evo all is putting out tach signal?
Login to reply View 2 answer(s)

10/04/2017

 Honda julio pelayo (1650Pts.)

0

Car over cranking

Hi, i installed a crimestopper with a evo all on a 2013 civic, i set tach learning mode on crimestopper but sometimes it over cranks. If i hardwire tach wire from evo to crimestopper will it help with the over cranking? Crimestopper manual says when using a data module for tach signal do not connect tach wire, this will create a conflict. The system can only use one tach source. If i hardwire tach wire evo all to crimestopper it's still the same source right? And should not have any conflict?
Login to reply View 1 answer(s)

18/03/2017

 Honda vincent m (410Pts.)

0

what is the difference between regular install from install with doorlock optimization in honda civic

option installation of evo one with regular install w/ t harness versus t-harness w doorlock optimization install
Login to reply View 1 answer(s)

12/03/2017

 Honda julio pelayo (1650Pts.)

0

Remote starter no longer working 2013 civic

My remote starter crimestopper with evo all and t harness was working fine. I redid the install made the immo cut and reflashed to 73.23 put back in car and tried the crimestopper remote, lock unlock worked cranked but did not start green key flashing on dash, so i reprogrammed evo all and car started just fine, tried 3xlock and car does unlock lock but won't start, no crank no dash lights, blue light on evo comes on with every press of oem key fob then red light comes on for about 2-3 seconds. Now remote start not working at all not even with crimestopper remote, crimestopper does 3 chirp confirmation but thats all it does. Everything was working fine on old install even 3xlock
Login to reply View 1 answer(s)

09/03/2017

 Honda julio pelayo (1650Pts.)

0

Is thar hon2 t harness still the same? 2013 civic

My install is about a year 1/2 old and i want to redo my istall to the updated version the supports oem key fob functional while the car is running, is the immo ignition wire interruption all i need to do? Lock unlock wires are now on 20 pin plug, on old istall there on the red plug is that the only chage? After immo interruption the yellow wire still goes back to 20 pin plug do i leave that the same? One last question do i need option D1 on ? Its not a standalone istall I'm installing evo all with a crimestopper alarm/remote start but i want the 3xlock to work.
Login to reply View 1 answer(s)

10/01/2017

 Honda julio pelayo (1650Pts.)

0

Is firmware 73.18 beta safe or should I wait for the final release? 2013 Honda civic

If I re flash the module do i have to reprogram it?
Login to reply View 1 answer(s)

28/08/2015

 Honda julio pelayo (1650Pts.)

1

2013 civic 3x lock sets off crimestopper alarm

Installed evo all with crimestopper sp 402 set up with 3x lock to start but when I open the door with the key crimestopper alarm goes off.
Login to reply View 1 answer(s)

26/08/2015

 Honda julio pelayo (1650Pts.)

0

2013 civic alarm goes off when remote started.

Installed evo all with crimestopper sp 402, doors trunk pop tach it all works but when I remote start with crimes topper remote factory alarm goes off. Wired with data cable, evo all doesn't do ome disarm?
Login to reply View 1 answer(s)

No results

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

TECHNICAL SUPPORT

Search through our most popular products and installation topics available in our Question & Answers section.

Learn more
Download our step-by-step troubleshooting guides app available for both iOS and Android or browse through our desktop version.

Learn more
Access the industry’s largest online wiring diagrams & photo database. A free token is provided in every EVO-SERIES box.

Learn more
You did not find the information that you were lookingfor? Ask us a question by filling out the technical support form request. A product specialist will answer you shortly.

Learn more
From state-of-the-art vehicle remote control and connectivity solutions to premium technical support, learn why you should choose Fortin products.

Learn more

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue